Bunn Dual TF BrewWISE DBC Guía para resolver problemas descargar pdf (Pagina 20)

TF BrewWISE

Training Manual

□ Clean any mineral build-up from the valve

□ Reassembly is the opposite of disassembly

Step6:Cleanthetankttingsthatsupplywatertothesolenoidvalves(Notedependingontheageofthebrewerthis

will be either a single “T” connector or individual connectors for the dispense and bypass tubes.)

□ Remove the clip from the end of tubes

□ Gentlyremovethetubingfromthetankttings

□ Useascrewdrivertoremoveandmineralbuild-upfromthettings

□ Reattach the tubing and clips

Step 7: Remove and clean the temperature sensor

□ Gently pull the temperature sensor from the grommet in the top of the tank

□ Wipe any mineral build-up from the sensor

□ Reinstallation is the opposite of removal

Step8:Removeandcleanthellprobe

□ Gentlypullthellprobeoutofthegrommet

□ Wipe any mineral deposits off of the probe

Step 9: Remove and clean the sprayheads

□ Using the pointed end of the deliming tool, remove any mineral build-up from the sprayhead outlet holes

Step 10: Replace the seat cups in all the TF server faucets

□ Ensure the server is completely empty

□ Unscrew the faucet bonnet from the assembly

□ Remove the old faucet seat cup

□ Install the new seat cup.

□ Reassembly is the opposite of disassembly

Step 11: Replace the seat cup in the hot water faucet

□ Unscrew the faucet bonnet from the assembly

□ Remove the old faucet seat cup

□ Install the new seat cup.

□ Reassembly is the opposite of disassembly

Step 12: Check funnels, handle and tip are tight

□ Ensure the screw securing the handle to the funnel is tight

□ Ensure the funnel tip, the bottom outlet, is tight

□ Check funnels for proper operation

Step 14: Examine water supply for any leaks, reconnect water supply

Step 13: Examine power cord for any damage, reconnect power supply

Step 15: Check the funnel lock solenoids for proper operation (Note the brewer must be on to perform this step)

□ Manually activate each funnel lock in the Systems Tools menu

Step16:Calibrateowrates(Notethebrewermustbeontoperformthisstep)

□ Follow the procedures in section 2 of this manual

Step 17: Check the TF servers for proper operation.

□ Check for Leaks and proper venting through the lid assembly.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

Sin comentarios

Bunn Dual TF BrewWISE DBC Guía para resolver problemas Pagina 20